Hyundai Veloster: Brake System
Hyundai Veloster 2011-2017 Service Manual / Brake System
Hyundai Veloster 2011-2017 Service Manual / Brake System
- General Information
- Brake System
- Description and Operation
- Brake Booster. Components and Components Location
- Brake Booster. Repair procedures
- Master Cylinder. Components and Components Location
- Master Cylinder. Repair procedures
- Brake Line. Components and Components Location
- Brake Line. Repair procedures
- Brake Pedal. Components and Components Location
- Brake Pedal. Repair procedures
- Front Disc Brake. Components and Components Location
- Front Disc Brake. Repair procedures
- Rear Disc Brake. Components and Components Location
- Rear Disc Brake. Repair procedures
- Parking Brake System
- ESC(Electronic Stability Control) System
- Components and Components Location
- Description and Operation
- Schematic Diagrams
- Troubleshooting
- EBD(Electronic Brake-force Distribution). Description and Operation
- ESC Control Module. Components and Components Location
- ESC Control Module. Repair procedures
- Front Wheel Speed Sensor. Components and Components Location
- Front Wheel Speed Sensor. Repair procedures
- Rear Wheel Speed Sensor. Components and Components Location
- Rear Wheel Speed Sensor. Repair procedures
- Yaw-rate and Lateral G Sensor. Description and Operation
- Yaw-rate and Lateral G Sensor. Repair procedures
- ESC OFF Switch. Description and Operation
- ESC OFF Switch. Repair procedures
- Steering Angle Sensor. Description and Operation
Seat Belt Pretensioner (BPT). Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the lower anchor b ...
See also:
Canister Close Valve (CCV). Description and Operation
Description
Canister Close Valve (CCV) is normally open and is installed on the canister
ventilation line. It seals evaporative emission control system by shutting the
canister from the atmo ...
Fuel Tank Pressure Sensor (FTPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specifica ...
Clutch Actuator Motor 2 (Even Gear) > Repair procedures
Inspection
1.
Turn off the ignition switch.
2.
Disconnect the clutch motor connector.
3.
Measure the resista ...
Categories
В© 2011-2025 Copyright www.hvmanual.com