Hyundai Veloster Manuals

Hyundai Veloster: Rear Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Veloster: Rear Wheel Speed Sensor. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures

Removal

1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.0 ~ 8.0 lb-ft)

3.
Remove the rear seat back.
(Refer to the Body group - Seat)
4.
Remove the rear wheel housing trim.
(Refer to the Body group – interior trim)
5.
Disconnect the rear wheel speed sensor connector.
6.
Installation is the reverse of removal.

Inspection

1.
Measure the output voltage between the terminal of the wheel speed sensor and the body ground.
•
In order to protect the wheel speed sensor, when measuring output voltage, a 100 Ω resister must be used as shown.

2.
Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low: 0.59 ~ 0.84 V
V_high: 1.18 V ~ 1.68 V
Frequency range: 1 ~ 2,500 Hz

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor connector ...

Yaw-rate and Lateral G Sensor. Description and Operation
Description When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sens ...

See also:

Defogging logic
To reduce the probability of fogging up the inside of the windshield, the air intake or air conditioning are controlled automatically according to certain conditions such as or position.To canc ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

Sunshade
The sunshade will automatically open, when you push the sunroof control lever backward to the first detent and then release it. The sunshade will automatically close, when you push the sunroof co ...

Categories

© 2011-2026 Copyright www.hvmanual.com