Hyundai Veloster: Maintenance
Hyundai Veloster 2011-2017 Owner's Manual / Maintenance
Hyundai Veloster 2011-2017 Owner's Manual / Maintenance
- Engine compartment
- Maintenance services
- Owner maintenance
- Scheduled maintenance service
- Explanation of scheduled maintenance items
- Engine oil
- Engine coolant
- Brake/clutch fluid
- Washer fluid
- Parking brake
- Air cleaner
- Climate control air filter
- Wiper blades
- Battery
- Tires and wheels
- Tire care
- Recommended cold tire inflation pressures
- Checking tire inflation pressure
- Tire rotation
- Wheel alignment and tire balance
- Tire replacement
- Wheel replacement
- Tire traction
- Tire maintenance
- Tire sidewall labeling
- Tire terminology and definitions
- All season tires
- Summer tires
- Snow tires
- Tire chains
- Radial-ply tires
- Fuses
- Light bulbs
- Headlight, position light, turn signal light, front fog light bulb replacement
- Side repeater light bulb replacement
- Rear combination light bulb replacement
- High mounted stop light replacement
- License plate light bulb replacement
- Interior light bulb replacement
- Appearance care
- Emission control system
- 1. Crankcase emission control system
- 2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
- California perchlorate notice
Emergency towing
If towing is necessary, we recommend you to have it done by an authorized Hyundai
dealer or a commercial tow truck service.
If towing service is not available in an emergency, your vehicle may be ...
Engine compartment
Gasoline 1.6 GDI
1. Engine coolant reservoir 2. Engine oil filler cap 3. Brake/clutch* fluid
reservoir 4. Positive battery terminal 5. Negative battery terminal 6. Fuse
box 7. Air cleaner 8. Ra ...
See also:
Checking the engine oil level
1. Be sure the vehicle is on level ground. 2. Start the engine and allow it
to reach normal operating temperature. 3. Turn the engine off and wait for a few
minutes (about 5 minutes) for the oil ...
Start/Stop Button. Components and Components Location
Component
...
Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
...
Categories
В© 2011-2019 Copyright www.hvmanual.com