Hyundai Veloster: Emission control system
Hyundai Veloster 2011-2017 Owner's Manual / Maintenance / Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle.
Your vehicle is equipped with an emission control system to meet all applicable emission regulations.
There are three emission control systems, as follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to assure the proper function of the emission control systems, it is recommended that you have your car inspected and maintained by an authorized HYUNDAI dealer in accordance with the maintenance schedule in this manual.
Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)
- To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch.
- After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.
- 1. Crankcase emission control system
- 2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
Interior care
Interior general precautions
Prevent caustic solutions such as perfume and cosmetic oil from contacting the
dashboard because they may cause damage or discoloration. If they do contact the
dashbo ...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase. This system supplies fresh
filtered air to the crankcase th ...
See also:
Front seat adjustment
Forward and backward
Type A
To move the seat forward or backward:
1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to
the position you desire. 3. Release the lever and ...
Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto ligh ...
Fuel Pressure Control Valve. Repair procedures
Inspection
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the fuel pressure regulator valve ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
