Hyundai Veloster: High mounted stop light replacement
Hyundai Veloster 2011-2017 Owner's Manual / Maintenance / Light bulbs / High mounted stop light replacement
If the light does not operate, have the vehicle checked by an authorized HYUNDAI dealer.
3. Loosen the assembly retaining nuts.
4. Remove the rear combination light
assembly from the body of the vehicle.
Rear combination light bulb replacement
(1) Stop and tail light (2) Back-up light (3) Rear turn signal light (4)
Tail light
Outside
1. Open the tailgate. 2. Loosen the outside light assembly retaining screws
with a cross-tip screw ...
License plate light bulb replacement
1. Open the tailgate. 2. Remove the tailgate trim by removing the plastic mounting
clips.
CAUTION
Be careful when removing the plastic mounting clips in cold weather, it
may crack.
3. Remove ...
See also:
ESC OFF Switch. Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad lower panel.
(Refer ...
Transmitter precautions
✽ NOTICE
The transmitter will not work if any of following occur:
• The ignition key is in ignition switch.
• You exceed the operating distance limit (about 90 feet [30 m]).
• Th ...
Setting the tire inflation pressure
12. After driving approximately 2 miles (3 km), stop at a suitable location.
13. Connect connection hose (9) of the compressor directly to the tire valve.
14. Connect between compressor and the ve ...