Hyundai Veloster Manuals

Hyundai Veloster: Input Speed Sensor 2 > Repair procedures - Dual Clutch Transmission Control System - Dual Clutch Transmission(DCT) SystemHyundai Veloster: Input Speed Sensor 2 > Repair procedures

Inspection

Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.

Removal

1.
Remove the under cover.
2.
Disconnect the input shaft speed sensor connector (A).

3.
Loosen the mounting bolt and then remove the input shaft speed sensor (B).


Installation

1.
Installation is the reverse of removal.

Tightening torque : 1.0 ~ 1.2 kgf.m


Input Speed Sensor 2 > Description and Operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the TCM. It provides important input information for electric contr ...

Inhibitor Switch > Description and Operation
Description The inhibitor switch is mounted on the transmission case. It includes the electric switch plate circuit and is directly connected with the transmission lever via transmission cab ...

See also:

Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your loaded vehicle weight within its design rating capability. Properly loading your vehicle will provide maximum return ...

Components and Components Location
Component Location 1. Hood switch 2. Burglar horn 3. IPM (BCM) and RF antenna 4. Key warning switch 5. Front door switch 6. Front door lock actuator & sw ...

Manifold Absolute Pressure Sensor (MAPS). Specifications
Specification Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 ...

Categories

В© 2011-2026 Copyright www.hvmanual.com