(1) Stop and tail light
(2) Back-up light
(3) Rear turn signal light
(4)
Tail light
Outside
1. Open the tailgate.
2. Loosen the outside light assembly retaining screws
with a cross-tip screwdriver.
3. Remove the rear combination light assembly from
the body of the vehicle.
4. Remove the socket from the assembly by turning the
socket counterclockwise until the tabs on the socket align with the slots on the
assembly.
5. Remove the bulb from the socket.
6. Insert a new bulb by inserting
it into the socket and pushing or rotating it until it locks into place.
7. Install
the socket in the assembly by aligning the tabs on the socket with the slots in
the assembly. Push the socket into the assembly and turn the socket clockwise.
8. Reinstall the light assembly to the body of the vehicle.
9. Tighten the screws.
Light bulbs
WARNING - Working on the lights
Prior to working on the light, firmly apply the parking brake, ensure that
the ignition switch is turned to the LOCK position and turn off the lights to avoid
sudd ...
Repair procedures
On-vehicle Inspection
Spark Test
1.
Remove the engine cover (A).
2.
Disconnect the ignition coil connectors (A).
...
Instrument Cluster. Components and Components Location
Components
...