Inspection
1. |
Turn off the ignition switch.
|
2. |
Disconnect the gear actuator motor connector.
|
3. |
Measure the resistance on the gear actuator motor terminal.
|
4. |
Refer to the specifications and check that the measured resistance
is as specified.
|
Removal
1. |
Remove the gear actuator assembly.
(Refer to "Gear actuator" in this group)
|
Components and Components Location
Components
1. Battery insulation pad
2. Battery
3. Battery tray
4. Battery mounting bracket
5. ECM & bracket assembly
...
Instrument panel fuse replacement
1. Turn the ignition switch and all other switches off. 2. Open the fuse panel
cover.
3. Pull the suspected fuse straight out. Use the removal tool provided in the
engine compartment fuse pan ...
Steering Angle Sensor. Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine tur ...