Hyundai Veloster: Description and Operation

The Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary. The actuator is controlled according to the computed compensation value to obtain desired output.

If transmission or driving-performance-related failure is detected, first perform self-diagnosis and basic transmission inspection (oil check).

Then use the diagnostic tool to inspect the transmission control system components.

Dual Clutch Transmission Control System

...

Components and Components Location

Component Location 1. DCT (Dual Clutch Transmission) 2. DCT Control Module 3. Shift Lever 4. Data Link Connector (DLC) ...

See also:

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

Closing the hood
1. Before closing the hood, check the following: • All filler caps in engine compartment must be correctly installed. • Gloves, rags or any other combustible material must be removed from the e ...

Engine compartment fuse replacement
1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or inse ...