Hyundai Veloster: Cowl Top Cover. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body (Interior and Exterior) / Exterior / Cowl Top Cover. Repair procedures

Replacement

1.	Using a screwdriver or remover, remove the wiper arm cover (A).

2.	Remove the wiper arm mounting hole plug (B).

3.

After loosening the mounting nuts, then remove the wiper arm (A).

Tightening torque :

22.6 ~ 26.5 N.m (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)

4.	Remove the washer nozzle hose (B).

5.	Detach the clips, then remove the cowl top cover (A).

6.

Installation is the reverse of removal.

•	Replace any damage clips.

Mirror. Repair procedures

Replacement Outside Rear View Mirror Replacement • When prying with a flat-tip screwdriver, ...

Interior

...

See also:

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output ...

Repair procedures
Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replac ...

Input Speed Sensor 1 > Description and Operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the TCM. It provides important input information for electric contr ...

Categories

© 2011-2026 Copyright www.hvmanual.com