Hyundai Veloster Manuals

Hyundai Veloster: Mirror. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Veloster: Mirror. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body (Interior and Exterior) / Exterior / Mirror. Repair procedures

Replacement

Outside Rear View Mirror Replacement
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).
2.
Disconnect the outside rear view mirror connector (A).
3.
After loosening the mounting bolts, then remove the outside rear view mirror (B).
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Installation is the reverse of removal.
Inside Rear View Mirror Replacement
1.
Loosen the mounting screw (C).
2.
Push the inside rear view mirror base (B) up to remove to inside rear view mirror assembly (A).
3.
Installation is the reverse of removal.
ECM Mirror Replacement
1.
Remove the ECM mirror cover (B).
2.
Disconnect the ECM mirror connector (A).
3.
Loosen the mounting screw (B), push the ECM mirror base up to remove the ECM mirror assembly (A).
4.
Installation is the reverse of removal.
•
Make sure the connector are connected in properly.

Panoramaroof. Repair procedures
Replacements Movable glass Replacement 1. Open the movable glass fully. 2. After loosening the mounting screws, then remove the movabl ...

Cowl Top Cover. Repair procedures
Replacement 1. Using a screwdriver or remover, remove the wiper arm cover (A). 2. Remove the wiper arm mounting hole plug (B). ...

See also:

Specifications
Specifications Transaxle type M6CF1 Engine type Gasoline 1.6 GDI Gear ratio 1st 3.615 2n ...

Room lamp
• ON (1): In the ON position, the light stays on at all times. • DOOR (2) : In the DOOR position, the light comes on when any door is opened regardless of the ignition switch position. When d ...

Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp (map lamp) assembly then check for continuity between terminals. If the continuity is not as specified, replace the map ...

Categories


© 2011-2025 Copyright www.hvmanual.com