Hyundai Veloster Manuals

Hyundai Veloster: Rear Wiper Motor. Repair procedures - Rear Wiper/Washer - Body Electrical SystemHyundai Veloster: Rear Wiper Motor. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor. Repair procedures

Inspection

Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.

No
 Description
 No
 Description
1
 Battery
 3
 Switch
2
 Parking
 4
 Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the speed control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
3.
Connect terminals 2 and 3.
4.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4.
5.
Check that the motor stops running at the off position.

Removal

1.
Detach the rear wiper head cap (A).
2.
Remove the rear wiper arm & blade (A) after removing rear wiper arm nut (B).
3.
Remove the rear wiper grommet.
4.
Open the tailgate then remove the tailgate trim.
(Refer to the BD group - "Tailgate")
5.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts (3EA).

Installation

1.
Install the rear wiper motor assembly and the grommet.
Do not reuse the rubber pad if it is damaged.
2.
Install the tailgate trim.
(Refer to the BD group - "Tailgate")
3.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
4.
Set the rear washer nozzle on the specified spray position.
5.
Install the rear wiper cap and rear wiper nut.
Tightening torque Nut :
9.8 ~ 12.7 N.m (1.0 ~ 1.3 kgf.m, 7.24 ~ 9.38 lbf.ft)

Components and Components Location
Component Location 1. Rear wiper motor assembly 2. Rear wiper motor grommet 3. Rear wiper arm & blade 4. Nut ...

Rear Washer Switch. Repair procedures
Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and washer switch. Rear Wiper Switch ...

See also:

Connecting your unit and bluetooth phone
To connect using the unit settings (1) 1.Press on the control panel. 2.Touch [Bluetooth]. 3.Touch [Search for Bluetooth devices]. If you want to cancel, touch [Cancel]. 4.Touch a bluetooth pho ...

Console. Repair procedures
Replacement Floor Console Replacement [M/T] • A plastic trim tool is recommended, ...

Description and Operation
Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), ignition lock switch, connection wires and the battery cable. Whe ...

Categories

© 2011-2026 Copyright www.hvmanual.com