Hyundai Veloster Manuals

Hyundai Veloster: Clutch Actuator Motor 2 (Even Gear) > Repair procedures - Dual Clutch Transmission Control System - Dual Clutch Transmission(DCT) SystemHyundai Veloster: Clutch Actuator Motor 2 (Even Gear) > Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Clutch Actuator Motor 2 (Even Gear) > Repair procedures

Inspection

1.
Turn off the ignition switch.
2.
Disconnect the clutch motor connector.
3.
Measure the resistance on the clutch motor terminal.
4.
Refer to the specifications and check that the measured resistance is as specified.

Removal

1.
Remove the following parts first:
A.
Air cleaner assembly and air duct
(Refer to the Intake and Exhaust System of EM Group.)
B.
Battery and tray
(Refer to the Charging System of EE Group.)
C.
ECM
(Refer to the Engine Control Module of FL Group.)
2.
Disconnect the clutch actuator motor connector (A).
3.
Loosen the mounting screw, and then remove the clutch actuator motor (A).
Tightening Torque :
4.4 ~ 5.4 N.m (0.45 ~ 0.55 kgf.m, 3.3 ~ 4.0 lb-ft)


Installation

1.
Installation is the reverse of removal.
Clutch actuator spline (A) with grease before installation.
Specified grease [CSG-101M (0.1ml)]


Clutch Actuator Motor 2 (Even Gear) > Description and Operation
Description The clutch actuator motor is mounted on the DCT. The clutch actuator motor comprises an actuator motor that controls the odd clutch and an actuator motor that controls the even ...

Gear Actuator Motor > Description and Operation
Description The gear actuator motor is mounted on the complete shaft. The gear actuator motor comprises the shift motor and select motor. The gear actuator shift motor and select motor rec ...

See also:

Rear Seat. Components and Components Location
Components 1. Headrest [RH] 2. Headrest guide [RH] 3. Rear seat back cover [RH] 4. Rear seat cushion cover [RH] 5. Cup holder panel assembly 6. Headrest [LH] 7. H ...

Rear Glass Defogger Switch. Repair procedures
Inspection 1. The rear glass defogger switch inputs can be checked using the GDS. 2. To check the input value of rear glass defogger switc ...

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

Categories

В© 2011-2026 Copyright www.hvmanual.com