Hyundai Veloster Manuals

Hyundai Veloster: Rear Coil Spring. Repair procedures - Rear Suspension System - Suspension SystemHyundai Veloster: Rear Coil Spring. Repair procedures

Replacement

1.
Remove the rear wheel & tire.

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

Be careful not to damage to the hub bolts when removing the rear wheel & tire.
2.
Remove the rear shock absorber (A) from the frame by loosening the nut and then remove the coil spring.

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

3.
Installation is the reverse of removal.

Inspection

1.
Check the coil spring for crack and deformation.
2.
Check the coil spring pad for damage and deformation.

Rear Coil Spring. Components and Components Location
Components 1. Spring upper pad 2. Spring 3. Spring lower pad ...

Rear Torsion Beam Axle. Components and Components Location
Components 1. Rear torsion beam axle ...

See also:

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position. 2. Close the sunroof. 3. Release the sun ...

Repair procedures
On-vehicle Inspection Spark Test 1. Remove the engine cover (A). 2. Disconnect the ignition coil connectors (A). ...

Anchor Pretensioner (APT). Description and Operation
Description Front anchor pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver se ...

Categories


В© 2011-2023 Copyright www.hvmanual.com