1. Turn the ignition switch to the ON position.
2. Select the defrost button
().
3. Press the air intake control
button at least 5 times within 3 seconds.
The indicator on the air intake button blinks 3 times with 0.5 seconds of interval. It indicates that the defogging logic is canceled or returned to the programmed status.
If the battery has been discharged or disconnected, it resets to the defog logic status.
Seat Belt Pretensioner (BPT). Components and Components Location
Components
...
Engine Control Module (ECM). Repair procedures
Removal
When replacing the ECM, the vehicle equipped with immobilizer
must be performed the procedure as below.
...
Intake Air Temperature Sensor (IATS). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between th ...