Hyundai Veloster: Input Speed Sensor 1 > Repair procedures
Hyundai Veloster 2011-2017 Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Input Speed Sensor 1 > Repair procedures
Hyundai Veloster 2011-2017 Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Input Speed Sensor 1 > Repair procedures
Inspection
Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.
Removal
| 1. |
Remove the under cover.
|
| 2. |
Disconnect the input shaft speed sensor connector (A).
|
| 3. |
Loosen the mounting bolt and then remove the input shaft speed
sensor (B).
|
Installation
| 1. |
Installation is the reverse of removal.
|
Input Speed Sensor 1 > Description and Operation
Description
The input shaft speed sensor is important in that it detects the input
shaft RPM and sends this information to the TCM. It provides important input
information for electric contr ...
Input Speed Sensor 2 > Description and Operation
Description
The input shaft speed sensor is important in that it detects the input
shaft RPM and sends this information to the TCM. It provides important input
information for electric contr ...
See also:
Gear Actuator > Repair procedures
Removal
1.
Remove the following parts first:
A.
Air cleaner assembly and air duct
(Refer to the Intake and Exhaust System of EM Gro ...
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
✽ NOT ...
Antenna Coil. Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad& ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
В© 2011-2026 Copyright www.hvmanual.com