Hyundai Veloster: Front Impact Sensor (FIS). Description and Operation

The front impact sensor (FIS) is installed in the front side member. They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.

SRS Control Module (SRSCM). Repair procedures

Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before b ...

Front Impact Sensor (FIS). Components and Components Location

Components ...

See also:

Concentric Slave Cylinder Assembly. Repair procedures
Removal 1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the concentric ...

Dual Clutch System. Description and Operation
Description The dual clutch is installed within the transmission. The dual clutch comprises an odd clutch and an even clutch. The odd clutch transfers and cuts off engine power to the tran ...

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...