Hyundai Veloster Manuals

Hyundai Veloster: AVN Remote Control. Repair procedures - AVN System - Body Electrical SystemHyundai Veloster: AVN Remote Control. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Body Electrical System / AVN System / AVN Remote Control. Repair procedures

Inspection

1.
Check the audio remote control switch (A) for resistance between connector terminals in each switch position.
[LH-AUDIO]

[RH-TRIP]

[Audio]
Switch
 Connector terminal
 Resistance
(±5%)
Seek up
 3-5
 430 Ω
Seek down
 3-5
 1.11 kΩ
Mode
 3-5
 2.11 kΩ
Volume up
 3-5
 4.61 kΩ
Volume down
 3-5
 6.81 kΩ

[Cruise]
Switch
 Connector terminal
 Resistance
(±5%)
ON/ OFF
 3-4
 880 Ω
Cancle
 3-4
 180 Ω
SET -
 3-4
 330 Ω
SET +
 3-4
 550 Ω

[Bluetooth + Voice]
Switch
 Connector terminal
 Resistance
(±5%)
Voice
 3-4
 10.71 kΩ
End of call
 3-4
 18.91 kΩ
Send
 3-4
 40.91 kΩ

[Trip + Reset]
Switch
 Connector terminal
 Resistance
(±5%)
Trip
 3-4
 2.54 kΩ
Reset
 3-4
 5.54 kΩ


Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group - "Driver airbag module and clock spring")
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Remove the steering wheel cover (A) after loosening 4 screws.
5.
Remove the steering wheel remote control switches connectors.
[LH-Audio/ Bluetooth + Voice]

[RH-Cruise/ Trip + Reset]
6.
Remove the wiring and loosen 5 screws.
7.
Remove the steering wheel remote control switch assembly (A).
8.
Remove the bluetooth switch and the trip switch (A) after loosening the screws.

Installation

1.
Install the steering wheel remote control switch.
2.
Install the steering wheel cover.
3.
Install the steering wheel.
4.
Install the driver airbag module.
Make sure the audio remote control switch and the airbag module connectors are plugged in properly.

AVN Remote Control. Schematic Diagrams
Circuit Diagram ...

Multimedia Jack. Schematic Diagrams
Circuit Diagram ...

See also:

Rheostat. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower switch(A). (Refer to the BD group - "Crash ...

Canister Close Valve (CCV). Schematic Diagrams
Circuit Diagram ...

2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
The Evaporative Emission Control System is designed to prevent fuel vapors from escaping into the atmosphere. (The ORVR system is designed to allow the vapors from the fuel tank to be loaded into ...

Categories

© 2011-2026 Copyright www.hvmanual.com