In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever.
If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on the windshield and obscure your vision.
CAUTION
ETC (Electronic Throttle Control) System. Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output ...
Manual climate control system
1. Turn the ignition switch to the ON position. 2. Select the defrost button
(). 3. Press the air intake control
button at least 5 times within 3 seconds.
The indicator on the air intake button ...
Playing an audio CD and MP3/ WMA/USB/iPod files
Disc
Insert a disc in the disc slot and playback will start automatically.
MP3/WMA CD
USB
You can play the files recorded in a USB memory device.
Connect a USB device to the USB port and playba ...