Hyundai Veloster Manuals

Hyundai Veloster: Specifications - General Information - Emission Control SystemHyundai Veloster: Specifications

Specifications

Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
22.0 ~ 26.0 [20°C(68°F)]

Fuel Tank Pressure Sensor (FTPS)
▷ Type: Piezo-Resistive Pressure Sensor
▷ Specification
Pressure [kPa (kgf/cm², in H2O)]
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5

Canister Close Valve (CCV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
19.5 ~ 22.5 [20°C(68°F)]


Tightening Torques

Item
kgf.m
N.m
lb-ft
Positive crankcase ventilation valve installation
0.8 ~ 1.2
7.8 ~ 11.8
5.8 ~ 8.7
Canister bracket installation bolt
2.0 ~ 3.0
19.6 ~ 29.4
14.5 ~ 21.7
Canister installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3
Fuel tank air filter installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3


Description and Operation
Description Emissions Control System consists of three major systems. • The Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. T ...

Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine strugg ...

See also:

Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher than the bottom of the wheel hub. Drive through any water slowly. Allow adequate stopping distance because brake perf ...

Clutch Release Cylinder. Repair procedures
Removal 1. Drain the brake fluid through the bleed plug (A). 2. Remove the clutch release cylinder assembly (C) after removing th ...

Brake Line. Components and Components Location
Components ...

Categories


© 2011-2025 Copyright www.hvmanual.com