Hyundai Veloster: Horn

Repair procedures

Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replac ...

Components and Components Location

Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn 4. Clock spring ...

See also:

Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance for normal driving. The tire label located on the driver's side center pillar gives the tire pressures reco ...

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 7,500 miles (12,000 km) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...

Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ...