Hyundai Veloster: Fuel Pressure Control Valve. Repair procedures
First generation (2011–present) / Hyundai Veloster 2010-2019 Service Manual / Fuel System / Engine Control System / Fuel Pressure Control Valve. Repair procedures
First generation (2011–present) / Hyundai Veloster 2010-2019 Service Manual / Fuel System / Engine Control System / Fuel Pressure Control Valve. Repair procedures
Inspection
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the fuel pressure regulator valve connector.
|
| 3. |
Measure resistance between the fuel pressure regulator valve terminals
1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram
...
Canister Close Valve (CCV). Description and Operation
Description
Canister Close Valve (CCV) is normally open and is installed on the canister
ventilation line. It seals evaporative emission control system by shutting the
canister from the atmo ...
See also:
Opening the hood
1.Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the
shift lever to the P(Park) pos ...
Rear Torsion Beam Axle. Repair procedures
Replacement
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the
turn signals, move the lever up or down (A). Green arrow indicators on the instrument
panel indicate which turn si ...
Categories
© 2011-2019 Copyright www.hvmanual.com