Hyundai Veloster Manuals

Hyundai Veloster: Troubleshooting - Indicators And Gauges - Body Electrical SystemHyundai Veloster: Troubleshooting

Hyundai Veloster 2011-2017 Service Manual / Body Electrical System / Indicators And Gauges / Troubleshooting

Troubleshooting

Symptom
 Possible cause
 Remedy
Tachometer does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
CAN line faulty
 Check the EMS
Tachometer faulty
 Check tachometer
Wiring or ground faulty
 Repair if necessary
Fuel gauge does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Fuel gauge faulty
 Check gauge
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Low fuel warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Fuel sender faulty
 Check fuel sender
Wiring or ground faulty
 Repair if necessary
Water temperature gauge does not operate
 Cluster fuse (10A) blown
 Check for short and replace fuse
Water temperature gauge faulty
 Check gauge
Water temperature sender faulty
 Check sender
CAN line faulty
 Check the EMS
Wiring or ground faulty
 Repair if necessary
Oil pressure warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Oil pressure switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Parking brake warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
Brake fluid level warning switch faulty
 Check switch
Parking brake switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
CAN line faulty
 Check the TCS/ABS (EBD)
Check the Smart Junction Box(SJB)
(Parking brake/Brake oil switch)
Open door warning lamp and trunk warning lamp do not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
CAN line faulty
 Check the Smart Junction Box(SJB)
Door switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary
Speedometer does not operate
 Vehicle speed sensor faulty
 Check the vehicle speed sensor (M/T)
CAN line faulty
 Check the EMS (A/T)
Seat belt warning lamp does not light up
 Cluster fuse (10A) blown
 Check for short and replace fuse
Bulb burned out
 Replace bulb
CAN line faulty
 Check the BCM
Seat belt switch faulty
 Check switch
Wiring or ground faulty
 Repair if necessary


Instrument Cluster. Description and Operation
Active ECO System 1. Active ECO System While the general eco system encourages the driver to drive efficiently by displaying ECO lights on the dashboard, the activ ...

Power Door Locks
...

See also:

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...

SRS Control Module (SRSCM). Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before b ...

Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. To reduce the ...

Categories

В© 2011-2026 Copyright www.hvmanual.com