Hyundai Veloster Manuals

Hyundai Veloster: TPMS Receiver. Description and Operation - Tire Pressure Monitoring System - Suspension SystemHyundai Veloster: TPMS Receiver. Description and Operation

Hyundai Veloster 2011-2017 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver. Description and Operation

Description

Function

1.
LED control, Vehicle Speed signal enter, Diagnostic function (via HS CAN Communications)
2.
Self Diagnosis / Circuit Check
3.
RF frame receive
4.
Tire air pressure, temperature, acceleration, battery data analysis.
5.
WE sensor ID Auto Learning

Operation

Operating mod

1.
Virgin
A.
Stock status
-
Sensor ID not entered
2.
EOL Test mod
A.
Conversion by Command (LID AA hex)
3.
OFF
A.
IG_OFF
4.
Normal
A.
IG_ON
B.
For the main action
-
LED lights up (pressure drop, MIL at the conditions)
-
Self Diagnosis / Circuit Check,
-
WE sensor monitoring
-
Tire air pressure, temperature data analysis.
-
WE sensor ID learning (IG_OFF -> IG_ON, driving over 26km/h during about 19 minutes.

TPMS Sensor. Repair procedures
Replacement 1. Remove the valve core and deflate the tire. 2. Remove the side of the tire bead area from the wheel using tire changing mac ...

TPMS Receiver. Repair procedures
Replacement When the receiver first arrives for replacement: 1) It will be in Virgin State. ...

See also:

Giving voice commands
1. Press () on the steering wheel remote control. 2. After the beep sounds, say "Help". All commands shall be listed which are presented in active fields. NOTE: If the command is n ...

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy Water leaks from panoramaroof Deteriorated roof lid weatherstrip Replace ...

Repair procedures
On-vehicle Inspection • Check that the battery cables are connected to the correct terminals ...

Categories


В© 2011-2025 Copyright www.hvmanual.com