Hyundai Veloster: Start/Stop Button. Repair procedures
Removal
| 1. |
Disconnect the negative(-) battery terminal.
|
| 2. |
Remove the center fascia panel assembly (A).
|
| 3. |
Disconnect the connector after loosening 2 screws, and then remove
the start/stop button (A).
|
Installation
| 1. |
Install the start/stop button.
|
| 2. |
Install the center fascia panel assembly.
|
Start/Stop Button. Components and Components LocationAntenna
Glass antenna (if equipped)
When the radio power switch is turned on while the ignition key is in either
the “ON� or “ACC� position, your car will receive both AM and FM broadcast signals ...
Measuring Body Dimensions
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will be illuminated for
your convenience, provided the ignition switch is not in the ON position. The light
will go off immediately when the ...