Hyundai Veloster: Parking Assist Sensor. Repair procedures
Removal
| 1. |
Remove the rear bumper.
(Refer to the Body group - "Rear bumper")
|
| 2. |
Disconnect the connector from the rear bumper.
|
| 3. |
Disconnect the connector(B) from the rear ultra sensor(A).
|
| 4. |
Pull out the sensor (A) by opening the sensor holder (C) out.
|
Installation
| 1. |
Install the rear ultra sensor after connecting the connector.
|
| 2. |
Install the rear bumper.
|
Loss of the smart key
A maximum of 2 smart keys can be registered to a single vehicle.
If you happen to lose your smart key, you will not be able to start the engine.
You should immediately take the vehicle and remainin ...
Engine Number
1.
Engine fuel
- G : Gasoline
2.
Engine range
- 4 : 4 cycle 4 cylinder
3.
Engine developmen ...
Windshield Wiper-Washer Switch. Repair procedures
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer S ...