Hyundai Veloster Manuals

Hyundai Veloster: Measuring Actual Dimensions - General InformationHyundai Veloster: Measuring Actual Dimensions

Hyundai Veloster 2011-2017 Service Manual / General Information / Measuring Actual Dimensions

1.
These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurement.
2.
First adjust both probes to the same length (A=A') before measurement.
Check the probes and gauge itself to make sure there is no free play.

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body ...

Measurement Point
Measurements should be taken at the center of the hole. ...

See also:

SRS Control Module (SRSCM). Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before b ...

Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows: 1. Turn the ignition switch to the ON position. 2. Close the sunroof. 3. Release the sun ...

Anchor Pretensioner (APT). Components and Components Location
Components ...

Categories

В© 2011-2026 Copyright www.hvmanual.com