Hyundai Veloster Manuals

Hyundai Veloster: Fog Lamps. Repair procedures - Lighting System - Body Electrical SystemHyundai Veloster: Fog Lamps. Repair procedures

Inspection

1.
Disconnect the negative (-) battery terminal.
2.
Remove the lighting switch of the multifunction switch.
(Refer to the "Multifunction Switch")
3.
With the front fog lamp switch, make sure that continuity exists between the terminals below.
If continuity is not as specified, replace the multifunction switch.

Fog lamp switch


Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove the front bumper.
(Refer to the BD group - "Front bumper")
3.
Remove the front fog lamp connector(A) from the front bumper.
4.
Remove the front fog bulb(A) turning it in the counterclockwise direction.

5.
Remove the front fog lamp assembly(A).


Installation

1.
Install the front fog bulb.
2.
Reconnect the lamp connector.
3.
Install the front bumper.

Rheostat. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower switch(A). (Refer to the BD group - "Crash ...

High Mounted stop lamp. Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the tailgate center trim. (Refer to the BD group - "Exterior - T ...

See also:

Components and Components Location
Components Location 1. AVN (A/V & Navigation head unit) 2. Midrange speaker 3. External amplifier 4. Glass antenna amplifier (Radio) 5. Front door speaker 6. Rea ...

Crankshaft Position Sensor (CKPS). Repair procedures
Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Re ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door delta inner cover 3. Rear door inside handle cap 4. Rear door trim seal 5. Rear door panel assembly 6. Rear door be ...

Categories

© 2011-2026 Copyright www.hvmanual.com