Hyundai Veloster: Curtain Airbag (CAB) Module. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Advanced) / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.

2.	Remove the roof trim. (Refer to the Body group - "Interior")

3.	Disconnect the curtain airbag harness connector (A).

4.	After loosening the mounting bolts remove the curtain airbag.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes.

Tighten the curtain airbag mounting bolts.

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb.ft)

•	Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.

4.	Connect the curtain airbag connector.

5.	Install the roof trim. (Refer to the Body group - "Interior")

6.	Reconnect the battery negative cable.

After installing the curtain airbag (CAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Curtain Airbag (CAB) Module. Components and Components Location

Components ...

Airbag Module Disposal. Description and Operation

Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbag ...

Hyundai Veloster: Curtain Airbag (CAB) Module. Repair procedures

Curtain Airbag (CAB) Module. Components and Components Location

Airbag Module Disposal. Description and Operation

See also:

Categories