Hyundai Veloster: Windshield Wiper-Washer Switch. Repair procedures
Inspection

Wiper Switch

Washer Switch

Removal
| 1. |
Remove the steering column upper and lower shrouds (A) after removing
3 screws.
|
| 2. |
Disconnect the connector(A).
|
| 3. |
If necessary of removing the wiper & washer switch (A), release
the lock of wiper switch using tool without removing the steering wheel
and the clock spring.
|
| 4. |
Remove the steering wheel.
(Refer to the ST group - "Steering column and shaft")
|
| 5. |
Remove the clock spring.
(Refer to the RT group - "Airbag module")
|
| 6. |
Remove the multifunction switch assembly(A) with 2 screws.
|
Installation
| 1. |
Install the multifunction switch after connecting the connector.
|
| 2. |
Install the clock spring and steering.
|
| 3. |
Install the upper and lower shroud.
|
| 4. |
Install the steering wheel.
|
Components and Components Location
Front Wiper Motor. Components and Components LocationClimate control air filter
Filter inspection
The climate control air filter should be replaced according to the Maintenance
Schedule. If the vehicle is operated in severely air-polluted cities or on dusty
rough roads for a ...
Antenna
Glass antenna (if equipped)
When the radio power switch is turned on while the ignition key is in either
the “ON” or “ACC” position, your car will receive both AM and FM broadcast signals ...
Side Impact Sensor (SIS). Components and Components Location
Components
...