Hyundai Veloster Manuals

Hyundai Veloster: Troubleshooting - Hands Free System - Body Electrical SystemHyundai Veloster: Troubleshooting

Hyundai Veloster 2011-2017 Service Manual / Body Electrical System / Hands Free System / Troubleshooting

Troubleshooting

Problem
 Possible cause
 Solution
Not pairing
 Bluetooth device of Car is not discoverable mode
 Enter Bluetooth pairing (searching) mode
User’s phone is Bluetooth off mode
 User’s phone set Bluetooth on
Making an attempt pairing others bluetooth system
 Check Bluetooth device name and address (12 word) to attempt paring
Ex) 000B24FFF123
Pass key error
 Input the passkey displayed on the audio screen into the phone.
5 phones have already been registered.
 Delete paired phone list
Bluetooth system cannot communicate with the phone.
 Refer to IOP sheet
 ※IOP : Inter-operability
Not connection
 User’s phone or Bluetooth device of Car does not register Bluetooth device to connect
 Retry pairing
Bluetooth system cannot communicate with the phone.
 Wait 1minute then Retry connection or phone power off/on.
Refer to IOP sheet
Not redial
User phone system issue
 Push the Send button 2 times
Not accept call
 User phone system issue
 Refer to IOP sheet
Not dialing
 User’s phone playing other menu (internet, mp3, game, etc..)
 Stop other menu then set normal mode
Bluetooth system cannot communicate with the phone
 Refer to IOP sheet


Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

Panoramaroof
...

See also:

Smart key. Repair procedures
Smart Key Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. ...

To increase cruise control set speed
Follow either of these procedures: Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release the lever at the speed you want. Move the lever up (to RES+) and release it ...

Input Speed Sensor 1 > Repair procedures
Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Remove the under cover. 2. Disconnect the inp ...

Categories

© 2011-2026 Copyright www.hvmanual.com