Hyundai Veloster Manuals

Hyundai Veloster: Side Airbag (SAB) Module. Repair procedures - Airbag Module - Restraint (Advanced)Hyundai Veloster: Side Airbag (SAB) Module. Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Restraint (Advanced) / Airbag Module / Side Airbag (SAB) Module. Repair procedures

Removal

The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly.
(Refer to the Body group - "Seat")
3.
Remove the seat back assembly.
(Refer to the Body group - "Seat")

Installation

Be sure to install the harness wires not to be pinched or interfered with other parts.
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
(Refer to the Body group - "Seat")
4.
Install the front seat assembly.
(Refer to the Body group - "Seat")
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module. Components and Components Location
Components ...

Curtain Airbag (CAB) Module. Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain ...

See also:

Manifold Absolute Pressure Sensor (MAPS). Description and Operation
Description Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog ...

Manual transaxle operation
The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to either a higher or a lower gea ...

Headlight, position light, turn signal light, front fog light bulb replacement
(1) Headlight (Low) (2) Headlight (High) (3) Front turn signal light (4) Position/DRL light (5) Front fog light* Headlight bulb WARNING - Halogen bulbs • Halogen bulbs contain pressurize ...

Categories

© 2011-2026 Copyright www.hvmanual.com