Hyundai Veloster: Repair procedures
Inspection
| 1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
| 2. |
Reconnect the PCV valve to the vapor hose.
|
| 3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
Schematic Diagrams
Positive Crankcase Ventilation (PCV) Valve. Description and OperationGeneral Information
General
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure ...
Troubleshooting
Trouble Symptom Charts
Trouble Symptom 1
Trouble Symptom 2
Trouble symptom
Probable cause
Remedy
The set vehicle speed varies ...
Repair procedures
Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. The GDS
operates actuator quickly to monitor, input/output value and self diagnosis.
T ...