Hyundai Veloster: Precautions For Catalytic Converter
If a large amount of unburned gasoline flows into the converter,
it may overheat and create a fire hazard. To prevent this observe the
following precautions and explain them to your customer.
|
| 1. |
Use only unleaded gasoline.
|
| 2. |
Do not run the engine while the car is at rest for a long time.
Avoid running the engine at fast idle for more than 10minutes and idle
speed for more than 20 minutes.
|
| 3. |
Do not measure engine compression for an extended time. Engine
compression tests must be made as rapidly as possible. Remove the fuel
pump relay before performing a compression test.
|
| 4. |
Do not dispose of used catalytic converter together with parts
contaminated with gasoline or oil.
|
Servicing The Electrical SystemComponents and Components Location
Component Location
1. Hood switch
2. Burglar horn
3. IPM (BCM) and RF antenna
4. Key warning switch
5. Front door switch
6. Front door lock actuator & sw ...
DCT Control Modle (TCM) > Repair procedures
Inspection
TCM Inspection Procedure
1.
Inspecting TCM ground circuit: Measure the resistance between
the TCM and chassis ground.
(Check the termina ...
Troubleshooting
Troubleshooting
Symptom
Possible cause
Remedy
Hard steering
Improper front wheel alignment
Excessive turning resistance of lower ar ...