Hyundai Veloster: Measuring Body Dimensions
Hyundai Veloster 2011-2017 Service Manual / General Information / Measuring Body Dimensions
Hyundai Veloster 2011-2017 Service Manual / General Information / Measuring Body Dimensions
| 1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
| 2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
| 3. |
For measuring dimensions, both projected dimensions and actual
- measurement dimensions are used in this manual.
|
Rubber Parts And Tubes
Always prevent gasoline or from touching rubber parts or tubing.
...
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...
See also:
Purge Control Solenoid Valve (PCSV). Schematic Diagrams
Circuit Diagram
...
Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto ligh ...
Troubleshooting
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetoot ...
Categories
- Hyundai Veloster Manuals Home
- Hyundai Veloster 2010-2017 Owner's Manual
- Hyundai Veloster 2010-2017 Service Manual
В© 2011-2026 Copyright www.hvmanual.com