Hyundai Veloster Manuals

Hyundai Veloster: Dimensions Projected - General InformationHyundai Veloster: Dimensions Projected

1.
These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body alterations.
2.
If the length of the tracking gauge probes is adjustable, measure it by lengthening one of two probes as long as the different value in height of the two surface.

Measuring Body Dimensions
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Measuring Actual Dimensions
1. These dimensions indicate the actual linear distance between measurement points, and are used as the reference dimensions when a tracking gauge is used for measurem ...

See also:

TPMS Receiver. Description and Operation
Description Function 1. LED control, Vehicle Speed signal enter, Diagnostic function (via HS CAN Communications) 2. Self Diagnos ...

CVVT Oil Control Valve (OCV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the ...

Rear Door. Components and Components Location
Components 1. Rear door trim 2. Rear door delta inner cover 3. Rear door inside handle cap 4. Rear door trim seal 5. Rear door panel assembly 6. Rear door be ...

Categories

В© 2011-2026 Copyright www.hvmanual.com