Hyundai Veloster Manuals

Hyundai Veloster: Hands Free Switch. Repair procedures - Hands Free System - Body Electrical SystemHyundai Veloster: Hands Free Switch. Repair procedures

Inspection

1.
Check the hands free remote control switch for resistance between terminals in each switch position.

Switch
Connector terminal
Resistance
(±5%)
Voice
3 - 4
10.71 kΩ
End of call
3 - 4
18.91 kΩ
Send
3 - 4
40.91 kΩ


Removal

1.
Disconnect the negative(-) battery terminal.
2.
Remove th driver airbag module.
(Refer to the RT group - "Driver airbag(DAB) and clock spring)
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column and shaft")
4.
Remove the cover(A) after loosening screws.

5.
Disconnector the left audio switch (A).

6.
Disconnector the right hands free switch and trip switch (A).

7.
Remove the wiring (A) then loosening 5 screws.

8.
Remove the steering wheel remote control switchs assembly (A).


Installation

1.
Install the hands free switch to the steering wheel.
2.
Install the steering wheel cover.
3.
Install the steering wheel.
4.
Reassemble the driver airbag module.
Make sure the hands free remote control switch and the airbag module connectors are plugged in properly.

Hands Free Switch. Schematic Diagrams
Circuit Diagram ...

Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

See also:

Passenger Airbag (PAB) Module. Description and Operation
Description The passenger airbag (PAB) is installed inside the crash pad and protects the front passenger in the event of a frontal crash. The SRSCM determines if and when to deploy the PAB. ...

Rail Pressure Sensor (RPS). Specifications
Specification ...

Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided i ...

Categories

© 2011-2026 Copyright www.hvmanual.com