Hyundai Veloster Manuals

Hyundai Veloster: Fuel Tank Pressure Sensor (FTPS). Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: Fuel Tank Pressure Sensor (FTPS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.
Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD group).
3.
Remove the fuel pump service cover (A).
4.
Disconnect the fuel tank pressure sensor connector.
5.
Remove the fuel tank pressure sensor (A) after releasing the hooks vertically.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Installation is reverse of removal.

Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...

Injector. Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is c ...

See also:

Specifications
Specification Item Resistance (Ω) Driver Airbag (DAB) 1.7 ~ 2.3 Passenger Airbag (PAB) 1.7 ~ 2.3 ...

Fuel requirements
Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance ...

Interior Trim. Repair procedures
Replacement Door Scuff Trim Replacement • Put on gloves to protect your hands. ...

Categories

© 2011-2026 Copyright www.hvmanual.com