Hyundai Veloster Manuals

Hyundai Veloster: Crash Pad. Components and Components 
Location - Interior - Body (Interior and Exterior) - Hyundai Veloster 2010-2018 Service ManualHyundai Veloster: Crash Pad. Components and Components Location

Components

1. Main crash pad assembly
2. Center speaker grille
3. Center speaker assembly
4. Photo sensor
5. Cluster fascia lower panel
6. Cluster fascia upper panel
7. Side air vent duct [LH]
8. Crash pad side garnish
9. Cluster assembly
10. Center facia panel
11. Heater control unit
12. Start/stop button bezel
13. Audio assembly
14. Side air vent duct [RH]
15. Crash pad main lower panel
16. Glove box
17. Main wiring assembly
18. Cowl cross bar assembly


Console. Repair procedures
Replacement Floor Console Replacement [M/T] • A plastic trim tool is recommended, bu ...

Crash Pad. Repair procedures
Replacement Cluster Replacement • A plastic trim tool is recommended, but if prying with ...

See also:

Rear Coil Spring. Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

Dimensions Projected
1. These are the dimensions measured when the measurement points are projected from the vehicle's surface, and are the reference dimensions used for used for body ...

IPM (Intelligent integrated Platform Module). Description and Operation
Description IPM Overview The Body Control Module (IPM-Intelligent integrated Platform Module) supplies vehicle occupants with visual and audible information and it controls various vehic ...

Categories

© 2011-2018 Copyright www.hvmanual.com