Hyundai Veloster Manuals

Hyundai Veloster: Seat Heater Switch. Repair procedures - Seat Electrical - Body Electrical SystemHyundai Veloster: Seat Heater Switch. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center fascia panel (A).

3.
Remove the driver and the assist seat heater switch connector, after loosening 4 screws.


Installation

1.
Install th driver and the assist seat heater switch connector.
2.
Install the crash pad ceter fascia panel.
3.
Connect the battery (-) terminal.

Inspection

Rear seat heater switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center fascia panel.
3.
Disconnector the driver and the assist seat heater switch connector.

4.
Turn rear seat heater switch ON and check that continuity exists between the terminals.

5.
If there is no continuity, replace the seat heater switch.

Seat Heater Switch. Schematic Diagrams
Circuit Diagram ...

Seat Heater. Components and Components Location
Component Location ...

See also:

Navigation system
The navigation system ascertains the present position of your vehicle by using information from satellites and guides you to the place you assign as the destination. Detailed information for the na ...

Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative(-) battery terminal. 2. Remove the roof trim. (Refer to the BD group - "Roof trim") ...

Purge Control Solenoid Valve (PCSV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between th ...

Categories

В© 2011-2026 Copyright www.hvmanual.com