Hyundai Veloster Manuals

Hyundai Veloster: Rail Pressure Sensor (RPS). Repair procedures - Engine Control System - Fuel SystemHyundai Veloster: Rail Pressure Sensor (RPS). Repair procedures

Hyundai Veloster 2011-2017 Service Manual / Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
 Output Voltage (V)
Idle
  Approx. 1.2
1,500 rpm
 2.2 ~ 2.5
6,300 rpm
  Approx. 3.0


Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group).
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Rail Pressure Sensor Installation:
29.4 ~ 34.3 N.m (3.0 ~ 3.5 kgf.m, 21.7 ~ 25.3 lb-ft)

Rail Pressure Sensor (RPS). Schematic Diagrams
Circuit Diagram ...

Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important senso ...

See also:

Vehicle data collection and event data recorders
This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road ...

Checking the amount of air conditioner refrigerant and compressor lubricant
When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system. Therefore, if abnormal operation ...

License plate light bulb replacement
1. Open the tailgate. 2. Remove the tailgate trim by removing the plastic mounting clips. CAUTION Be careful when removing the plastic mounting clips in cold weather, it may crack. 3. Remove ...

Categories

© 2011-2026 Copyright www.hvmanual.com