Hyundai Veloster: Manual climate control system

To defog inside windshield
1. Select any fan speed except “0” position.
2. Select desired temperature.
3. Select the
or
position.
4. The outside (fresh)
air will be selected automatically. Additionally, the air conditioning will automatically
operate if the mode is selected to the
position.
If the air conditioning and outside (fresh) air position are not selected automatically, press the corresponding button manually.

To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature
to the extreme hot position.
3. Select the
position.
4. The outside (fresh)
air and air conditioning will be selected automatically.
If the air-conditioning, outside (fresh) air position and higher fan speed are not selected automatically, adjust the corresponding button or knob manually.
Windshield defrosting and defogging
Automatic climate control systemSmooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be he ...
Injector. Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance betwee ...
Setting the tire inflation pressure
12. After driving approximately 2 miles (3 km), stop at a suitable location.
13. Connect connection hose (9) of the compressor directly to the tire valve.
14. Connect between compressor and the ve ...