LOCK
The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position.
When turning the ignition switch to the LOCK position, push the key inward at the ACC position and turn the key toward the LOCK position.
ACC (Accessory)
The steering wheel is unlocked (if equipped) and electrical accessories are operative.
✽ NOTICE
If difficulty is experienced in turning the ignition switch to the ACC position, turn the key while turning the steering wheel right and left to release the tension.
ON
The warning lights can be checked before the engine is started. This is the normal running position after the engine is started.
Do not leave the ignition switch ON if the engine is not running to prevent battery discharge.
START
Turn the ignition switch to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position.The brake warning lamp can be checked in this position.
WARNING - Ignition switch
Clutch Master Cylinder. Repair procedures
Removal
•
Do not spill brake fluid on the vehicle; it may damage
the paint if brake fluid d ...
Roof Trim. Repair procedures
Replacement
Sunvisor Replacement
•
Use a plastic panel removal tool to remove
interior t ...
Bluetooth hands-free
You can use the phone wirelessly by using the Bluetooth.
Detailed information for the Bluetooth hands-free is described in the “Audio
section” in this chapter or in the manual supplied separate ...