Inspection
1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the roof trim.
(Refer to the BD group - "Roof trim")
|
3. |
Remove the handsfree mic (A) after disconnect the connector from
roof top.
|
4. |
Check the continuity of Mic between terminals.
|
Schematic Diagrams
System circuit diagram
Connector pin number
Pin No.
Discription
Remark
1
IG ON
...
Repair procedures
Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. The GDS
operates actuator quickly to monitor, input/output value and self diagnosis.
T ...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...