Hyundai Veloster: General Service Information
The support rod must be inserted into the hole near the edge of
the hood whenever you inspect the engine compartment to prevent the
hood from falling and causing possible injury.
Make sure that the support rod has been released prior to closing
the hood. Always check to be sure the hood is firmly latched before
driving the vehicle.
|
Meaning Of Symbols
Preparation Of Tools And Measuring EquipmentPanoramaroof. Repair procedures
Replacements
Movable glass Replacement
1.
Open the movable glass fully.
2.
After loosening the mounting screws, then remove
the movabl ...
Headlamp delay (if equipped)
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights remain on for about 20 minutes. However, if the driver’s door
is opened and closed, the headligh ...
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...