Replacement
1. |
Remove the fuel pump (Refer to “Fuel Pump” in this group).
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel
sender connector (B).
|
3. |
Remove the head assembly (A) after releasing the cushion fixing
clip (B).
|
4. |
Disconnect the fuel tube quick-connectors (C).
|
5. |
Remove the fuel sender (A) in the direction of an arrow.
|
6. |
Disconnect the fuel tube connector (A).
|
7. |
Remove the ORVR valve (A) after releasing hooks (B).
|
8. |
Remove the reservior-cup (B) after releasing the fixing hooks
(A).
|
9. |
Release the fixing hooks, and then remove the pre-filter (A) and
the fuel pressure regulator (B).
|
10. |
Replace new fuel filter.
1. Head assembly
2. Electric pump motor
3. Fuel filter
4. Fuel sender
5. Fuel pressure regulator
6. Pre-filter
7. Reservoir cup
8. ORVR valve
|
General Information
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Check the batter ...
Operating door locks from inside the vehicle
With the door lock button
To unlock a door, push the door lock button (1) to the “Unlock” position.
The red mark (2) on the button will be visible.
To lock a door, push the door lock bu ...
Front Impact Sensor (FIS). Description and Operation
Description
The front impact sensor (FIS) is installed in the front side member. They
are remote sensors that detect acceleration due to a collision at its mounting
location. The primary pur ...