Hyundai Veloster Manuals

Hyundai Veloster: Front Washer Motor. Repair procedures - Windshield Wiper/Washer - Body Electrical SystemHyundai Veloster: Front Washer Motor. Repair procedures

Inspection

1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.
3.
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.
4.
If they are abnormal, replace the washer motor.

Pin No.
Description
1
Ground
2
Front windshield washer (+)
3
Rear windshield washer (+)


Removal

-
When servicing the washer pump, be careful not to damage the washer pump seal.
-
Do not operate the washer pump before filling the washer reservoir.
Failure to do so could result in premature pump failure.
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front right tire and the wheel cover.
3.
Remove the washer hose and disconnect the washer motor connector (A).

4.
Remove the washer reservoir after removing 2 bolts (A).


Installation

1.
Install the washer reservoir.
Before installing the pump motor, check the filter for foreign material or contamination. if necessary, clean the filter into the pump motor.
2.
Install the washer motor.
3.
Install the washer hose.
4.
Connect the washer motor connector.
5.
Install the tire and the wheel cover.
6.
Check the washer motor operation.

Front Wiper Motor. Repair procedures
Removal 1. Remove the passenger cowl top cover (A) to remove passenger wiper blade. 2. Loosen the windshield wiper arm nut (B) aft ...

Rear Wiper/Washer
...

See also:

Special Service Tools
Special Tools Tool (Number and name) Illustration Use 09793-21000 Door hinge adjusting wrench Adjustment, removal ...

Canister Close Valve (CCV). Description and Operation
Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmo ...

Rear combination lamp. Repair procedures
Removal Rear Combination lamp 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after loosening 2 screws, an ...

Categories


В© 2011-2025 Copyright www.hvmanual.com