1. Turn the ignition switch and all other switches off.
2. Remove the fuse
panel cover by pressing the tab and pulling up.
3. Check the removed fuse; replace
it if it is blown. To remove or insert the fuse, use the fuse puller in the engine
compartment fuse panel.
4. Push in a new fuse of the same rating, and make sure
it fits tightly in the clips. If it fits loosely, consult an authorized HYUNDAI
dealer.
CAUTION
After checking the fuse panel in the engine compartment, securely install the fuse panel cover. If not, electrical failures may occur from water contact.
Multi fuse
If the multi fuse is blown, it must be removed as follows:
1. Remove the fuse panel in the engine compartment.
2. Remove the nuts shown
in the picture above.
3. Replace the fuse with a new one of the same rating.
4. Reinstall in the reverse order of removal.
✽ NOTICE
If the main or multi fuse is blown, consult an authorized HYUNDAI dealer.
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, ...
Dimensions Projected
1.
These are the dimensions measured when the measurement points
are projected from the vehicle's surface, and are the reference dimensions
used for used for body ...