Removal
1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
Turn the steering wheel so that the front wheels can face straight
ahead.
|
3. |
Remove the driver airbag module mounting bolts (2EA).
|
4. |
Remove the wiring fixing clip (C), and then release the connector
locking pin to disconnect the driver airbag module connector (B).
|
5. |
Remove the steering wheel and steering wheel column shroud. (Refer
to the Steering System group - "Steering Column and Shaft")
|
6. |
Disconnect the clock spring connector, then remove the clock spring.
|
Inspection
Driver Airbag (DAB) |
Never attempt to measure the circuit resistance of the airbag
module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.
|
1. |
Check pad cover for dents, cracks or deformities.
|
2. |
Check the airbag module for denting, cracking or deformation.
|
3. |
Check hooks and connectors for damage, terminals for deformities,
and harness for binds.
|
4. |
Check airbag inflator case for dents, cracks or deformities.
|
5. |
Install the airbag module to the steering wheel to check for fit
or alignment with the wheel.
|
1. |
If, as a result of the following checks, even one abnormal point
is discovered, replace the clock spring with a new one.
|
2. |
Check connectors and protective tube for damage, and terminals
for deformities.
|
Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
3. |
Connect the clock spring harness connector to the clock spring.
|
4. |
Install the steering column shroud.
|
5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 3.0 revolutions counterclockwise.
|
6. |
Install the steering wheel. (Refer to the Steering System group-
Steering Column and Shaft)
|
7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
9. |
Connect the battery negative cable.
|
10. |
After installing the airbag, confirm proper system operation:
|
Positive Crankcase Ventilation (PCV) Valve. Repair procedures
Removal
1.
Disconnect the vapor hose (A).
2.
Remove the PCV valve (B).
Inspection
1.
Insert a thin ...
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extra distance for braking.
Av ...
Special Service Tools
Special tools
Tool (Product number and name)
Shape
Function
09200-38001,09200-3N000
Engine support bar (beam)
Remov ...