Filter inspection
The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.
Filter replacement
1. Open the glove box.
2. Loosen the screws (1) and then remove the glove box inner panel (2).
3. Remove the climate control air filter cover while pressing the lock on the right side of the cover.
4. Replace the climate control air filter.
5. Reassemble in the reverse order
of disassembly.
✽ NOTICE
When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.
To decrease the cruising speed
Follow either of these procedures:
Move the lever down (to SET-) and hold it. Your vehicle will gradually
slow down. Release the lever at the speed you want to maintain.
Move the lever down ...
Side Impact Sensor (SIS). Repair procedures
Removal
Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
2.
Remo ...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Tr ...